Home/Outboards/Honda/Oil Filter Replacement

Oil Filter replacementOutboardsBF75A BF90A outboard motors

  1. Drain the engine oil, then reinstall the oil drain plug and cover, as described in the oil change procedure.
  2. Place a shop towel under the oil filter to absorb any spilled oil, then remove the oil filter with a special tool.Oil filter wrench
    TOOL:
    Oil filter wrench 07912 - 6110001
  3. Drain the used oil filter into a suitable container for oil disposal.
  4. Clean the filter mounting base, and coat the seal of the new oil filter with clean engine oil.Oil Filter NOTE:
    Use only a genuine Honda oil filter or a filter of equivalent quality specified for your model. Using the wrong Honda filter, or a non-Honda filter which is not of equivalent quality, may cause engine damage.
  5. Screw on the new oil filter by hand, until the seal contacts the filter mounting base, then use a special tool to tighten the filter an additional 7/8 turn.Tightening oil filter TORQUE: 22 N-m (2.2 kgf-m, 16 Ibf-ft)
    TOOL:
    Oil filter wrench 07912 - 6110001
  6. Refill the engine with the specified amount of the recommended oil, as described in the oil change procedure. Reinstall the oil filter cap and dipstick.
  7. Start the engine, and check for leaks.
  8. Stop the engine, and check the oil level. If necessary, add oil to the upper limit mark on the dipstick.
  9. Reinstall the engine cover.

Updated on: Tuesday, November 10, 2020

×

Navigation