Testing Oil Pressure 1100cc
2009 Arctic Cat Snowmobiles
- Locate the oil pressure sensor below the thermostat coolant hose, then disconnect the plug-in connector from the sensor.
- Using a 24 mm wrench, remove the oil pressure sensor from the engine.
- Using an oil pressure gauge and adapter, thread the adapter into the oil pressure sensor hole and tighten securely.
- Start the engine, run at 4000 RPM, and observe the oil pressure. The engine oil pressure specification is 2.04 kg/cm2 (29 psi)
20%. NOTE: This test must be done with the engine at running temperature. - After verifying oil pressure, remove the adapter and gauge from the engine, install the sensor, and tighten to 108 in.-Ib. Start the engine and check for oil leaks.
NOTE: Before installing the sensor, it may be necessary to apply thread sealant or teflon tape to the sensor threads.
CAUTION
Take care not to allow thread sealant or teflon tape into the oil passage or severe engine damage will occur.
Updated on: Thursday, December 24, 2020